News

Contact

Tel:086-755-81796865
Fax:086-755-28171850
Mob:086-13823368981

Skype: saiyang58
P.C:518109

Email:stchip@stchip.com
http://www.stchip.com

1208 Business Building JinLongHau Park, LongHua RD, ShenZhen, China

当前位置: Home > News > Enterprise News
Enterprise News

New product launch: SC5080B

The SC5080B are single-chip voice synthesizing CMOS IC. They are embedded EPROM architecture, and OTP (One Time Programmable) Speech chip,   Each body has one input and two I/O pins. Through accurate internal oscillation, external Rosc is unnecessary. There is PWM and 13bit DAC output for voice. Thus any external component is not required.Maximum 128 voice groups. serial mode maximum 255 voice groups ,moble One Group contain several steps(voice section ); Maximum 1536 steps and 16 steps volume control for all the Groups. Maximum 44.1Khz Play Rate,Maximum 80 seconds Voice/ Midi.Each Step can be define Trigger Mode, Output  Status,  Voice  Section,  Mute  length,  I/O  Type  &  Simple Programming  Function.   Support  three  mode  trigger  IC  (Stand  Alone,  Serial Trigger Mode ). Easy use development system is for function selection and voice combination . PC download the ROM code by the OTP_Writer.

 

2、Funtions :

(1).MAX voice file : 1536

(2).MAX Trigger Groups : 255

(3).MAX Step : 768
 (4).Operating Voltage range: 2.0V ~ 5.5V  

(5).Total Voice Duration : 80S (6K Samples)

(6).I/O pin : 3  

(7).Voice output : PWM/DAC

(8).Sequential Key : OKY1 -> 128 Groups.IO1-> 1 Group.IO1-> 1 Group

(9).Debounce time : 1ms us or 100 ms

(10)Step can change Trigger I/O Type, Trigger Mode & Output Status.

(11).SOP8 Package

(12).Three Mode Trigger IC :

(13).Key Stand-alone Trigger Mode :

A.  Edge/Level  

B.  Hold/Unhold

C.  Retrigger/Irretrigger

(14).Serial Trigger Mode :

Combinations of OKY to trigger maximum 127 Voice Group.

(15).Output status (for each Output pin):  

A.  Stand by Status. (High/Low Status)

B.  Busy Low Active.

C.  Busy High Active.

D.  LED Flash at 6 Hz.

E.  LED Flash at 3 Hz.

F.  LED Flash at 1.5 Hz.

G.  PWM for LED Dimming Control.

  1. PAD Description:

Pad No

Pad Name

Description

1

GND

Connected to Ground.

2

PA2/BUSY

Key Stand-alone Trigger Mode : is used trigger Only One Group.

 As Output PIN to Voice play busy

3

PA0/KEY

Key Stand-alone Trigger Mode : This used to trigger the maximum 128 Voice.

4

PA1/SDA

Serial  Mode : is used to control maximum 255 Voice Group

As Output PIN 

5

PWM1/DAC

As a PWM or DAC  PIN , can Directly drive the Speaker

 


http://www.stchip.com/upload/file/1605710886.pdf

分享到:
Hits:  UpdateTime:2020-11-18 23:37:13  【Printing】  【Close